FARGO electronic Card Printer User Manual download pdf (Page 18)

Getting Started

Section 3: Getting Started 13

A. CHOOSING A GOOD LOCATION

Place the unit in a location with adequate air circulation to prevent internal heat

build up.

■ Use the dimensions specified in Section 10 as a guideline for the minimum

clearances to the unit.

NOTE:

Allow for adequate clearance above the unit to accommodate the height of the unit with its

cover open.

■ Do not install unit (a) near heat sources such as radiators or air ducts, or (b) in a

place subject to direct sun-light, excessive dust, mechanical vibration or shock.

B. ABOUT MOISTURE CONDENSATION

If the unit is brought directly from a cold to a warm location, or is placed in a very

damp room, moisture may condense inside the unit. Should this occur, print quality

may not be optimum. Leave the unit turned OFF in a warm, dry room for several

hours before using. This will allow the moisture to evaporate.

510291_card printer 11/24/98 12:18 PM Page 13

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 95 96

No comments

FARGO electronic Card Printer User Manual Page 18